Usl JSD-100 Instrukcja Instalacji Pobierz pdf (Strona 12)

SX-2000 Installation Manual

11/8/2010

GDC Technology Ltd. Page 11 of 42

2.5.3 Series 2 projector setup

To work with the GDC IMB, the projector must be set up according to the requirements of the

projector manufacturer.

2.5.3.1 Barco Series 2 Projector

No system configuration is required for Barco Series 2 projector to work with the GDC IMB. The

Service Door/Marriage Tamper on the server must be cleared before the IMB can be used for

playback (refer to Section 3.1.2).

In order to use the IMB for content playback, the INPUT source of the projector macros must be

set to IMB (See Figure 13).

Figure 13 INPUT source settings on Barco Series 2 projector

2.5.3.2 NEC Series 2 Projector

In order to configure an NEC Series 2 projector to work with IMB, the following steps must be

taken:

Switch on the projector so that it is in STANDBY mode.

2. Use the Digital Cinema Communicator for S2 Windows software provided by NEC to

connect to the projector.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 41 42

Brak uwag

Usl JSD-100 Instrukcja Instalacji Strona 12